Applications:
1) All TITAN MOTOR CONTROLLERS (ESC)
2) Emeter v1 and RDU*
3) EOS 06xxi CHARGERS to PC Port for:
*EOS0610i NET and DUO - Firmware upgrades and PC Software
*EOS0606i DC and AC/DC - EOS INSIGHT PC Software

USING the TI-PRGUSB ADAPTER :
TITAN ESC
* Whenever connecting the PRGUSB Adapter, be sure that GRD/V+/Tx/Rx orientation is correct.
* For TITAN ESC, note that the "blanked" pin on the adapter connector is always next to GRD
*The Adapter supplies power to the TITAN ESC, so a battery pack must NOT be connected to the TITAN ESC during programming.

EMETER v1
*HP-TI-PRGUSB cannot be connected directly to EMETER v1. You must first insert the adapter for Emeter, which is included with every USB TI-PRGUSB. (pictured above, at bottom right of photo)
*For EMETER v1, note that you MUST turn Emeter ON first, then connect TI-PRGUSB to Emeter, when using Emeter PC Data Software.
(otherwise, you will see a "low battery" warning from Emeter...)

RDU (Remote Data Unit) uses HP-TI-PRGUSB alone (no adapter harness is needed)

EOS CHARGERS
*HP-TI-PRGUSB cannot be connected directly to EOS Chargers. A wiring harness/extension is needed between the charger and USB Adapter:

#HP-EOS06-PCCBL harness for PC Logging and Firmware Update:
EOS0610i-NET
EOS0610i-DUO
EOS0720i-NET
EOS0610i-DUO2

#HP-EOS0606-PCCBL harness for PC Logging Only
EOS0606i-AD (ac/dc, all versions)
EOS0606i (dc, all versions)

Note that only the hardware v3 Series EOS Chargers (0720i-NET3, DUO3, etc) do NOT need the TI-PRGUSB adapter, nor harness. They have built-in USB and cable. They do, however, need the same driver.

Please visit this webpage for more details